Comparison

PAC vs alum: which coagulant should you use?

How polyaluminium chloride and aluminium sulphate differ in performance, handling and cost, and how to decide for your plant.

Beaker of turbid water beside a beaker of clear water with settled sediment
Illustrative image · AI-generated, not our supplier's site

Nuocheng Trading · Published 2026-11-03

Aluminium sulphate (alum) and polyaluminium chloride (PAC) are both aluminium-based coagulants. They work on the same principle, but they behave differently in the plant. Here is a practical comparison.

The basic difference

Alum releases simple aluminium ions that hydrolyse in the water after dosing. PAC is pre-hydrolysed: part of that reaction already happened during manufacture, so PAC contains polymeric aluminium species from the start. The degree of pre-hydrolysis is expressed as basicity.

How they compare

AspectPACAlum
Effect on pH and alkalinitySmaller drop, because it is pre-neutralisedLarger drop; extra alkali (lime or soda) is often needed
Effective pH rangeGenerally widerNarrower
Cold, low-turbidity waterOften performs betterFloc forms more slowly
Floc formationUsually faster, denser flocSlower, lighter floc
DoseOften lower for the same resultOften higher
SludgeOften less sludgeOften more sludge
Price per kgHigherLower

These are general tendencies reported across the industry. Actual results depend on your water and the grades compared.

Compare cost per cubic metre, not cost per kg

Alum usually costs less per kilogram. But if PAC works at a lower dose, needs less pH correction and produces less sludge, the total treatment cost per cubic metre of water can be similar or lower. To compare fairly, add up:

  • Coagulant dose × price
  • Alkali needed for pH correction
  • Polymer dose, if used
  • Sludge handling and disposal

When alum may still be the better choice

  • Your water has plenty of natural alkalinity and stays at a comfortable temperature.
  • Your plant is built and tuned around alum and works well.
  • Sludge disposal is cheap and the lowest price per kg matters most.

How to decide

Run a jar test with your current alum dose as the reference and PAC at several doses. Measure settled turbidity, pH and sludge volume, then calculate the cost per cubic metre. That gives you a fair answer for your own water.

Want to try this with our PAC? Request a free 1 kg sample with COA. The sample is free; you cover the courier.

More articles